Steps if a device can only repond to SNMP v2 request
To force NFA to use SNMP v2 only.
1. Navigate to <NetFlow\conf> and open the system_properties.conf and add the following property in the very end.
SNMPTargetV2C=true
2. Start the NetFlow Analyzer service and check the issue.
1. Navigate to <NetFlow\conf> and open the system_properties.conf and add the following property in the very end.
SNMPTargetV2C=true
2. Start the NetFlow Analyzer service and check the issue.
New to ADSelfService Plus?
Related Articles
Steps to Update SNMP in NetFlow Analyzer version 12 and above
NetFlow Analyzer get the Device Name, Interface Name and Interface speed with SNMP configured on the device. We uses Read-only SNMP community configured in the device. You have to do SNMP update for devices in NetFlow Analyzer UI to get the correct ...SNMP walk - check if the router is responding to NFA's SNMP Request.
How to check if the router is responding to NetFlow Analyzer SNMP Request For Version 12 and above: In a CMD prompt, navigate to the NetFlow installation directory (OpManager\troubleshooting\). Execute SNMPWalk.bat for windows or SNMPWalk.sh for ...SNMP Test using Free Mib Browser tool for Windows
Please find the steps to Test SNMP if the SNMP update not working : RDP to the server where the Application is installed and follow the steps: 1. Open command prompt as Administrator ( Right Click on CMD -> Run As Administrator ). 2. Navigate to ...Device Expert_old
Note: These steps are only application over the Device Expert build 5990 with Postgres database. Also take the backup of complete DeviceExpert_Home directory after stopping the Device Expert service and proceed with the below steps. Stop the Device ...Associating SNMP credentials in NetFlow Analyzer