Changing snmp precision
We recently purchased some Inrow cooling solutions from APC.
Since there was no device template in OpManager i created a new one after downloading the MIBs from APC.
When I setup some bulk monitors i noticed that the values output as a 1/10 of a kW or 1/10 deg Cel.
This makes the monitor confusing, is there any way to do simple maths on the returned value such as snmp value / 10 to get the actual kW ?
thanks
Chris
Since there was no device template in OpManager i created a new one after downloading the MIBs from APC.
When I setup some bulk monitors i noticed that the values output as a 1/10 of a kW or 1/10 deg Cel.
This makes the monitor confusing, is there any way to do simple maths on the returned value such as snmp value / 10 to get the actual kW ?
thanks
Chris
Topic Participants
Chris Gibbs
Muthukumaran