For a SNMP Device, table OID returns no data.
Solution: If SNMP Device's table data is showing no data in the web
client then check all the OIDs of the particular table if they are returning proper values. This can
be verified using MibBrowser. If 1st OID doesn't respond then the
result will be null. Please check why
1st OID doesn't respond.
New to ADSelfService Plus?
Related Articles
SNMP Troubleshooting Guide
1) Please check the snmp agent is running in problematic remote server or not. 2) if it is running then execute the snmpwalk.bat / snmpwalk.sh This snmpwalk is used to check if the connectivity and the Discovery of the SNMP Server is possible from ...I am unable to add an enterprise specific SNMP OID or custom attributes in the SNMP/Network device for monitoring
The problem with the OIDs not getting added from the mibs was because the MIB file name and the MIBdefinition were different. The dependent MIBs may not be there in the mibs folder. Solution: The module name and file name should be same to ensure ...How can I verify SNMP connection and the OID values ?
If you want to verify if SNMP service is running fine in your server and check if the SNMP connection to the server is established, you can download and install our free tool MibBrowser. This tool can also be used to verify the values returned by ...SNMP is installed in the server and SNMP request is getting timed out
Make sure whether SNMP is installed and running in the server. Also refer here in case you are not able to view monitored data. If SNMP is running and the SNMP request is still getting timed out, follow the below troubleshooting steps : Check ...I am not able to view monitored data in SNMP mode, I get the "No data Available" message.
If you are not able to view the monitored data in SNMP mode, the following are the possible reasons : SNMP service is not enabled on the server. Make sure SNMP service is installed and is running. The SNMP request might have timed out. Refer here. ...