Traffic IN is not the same as traffic OUT on Foundry devices with sflow

Traffic IN is not the same as traffic OUT on Foundry devices with sflow

Hi,


we are using Netflow Analyzer 7.5 (7600) on a Linux Machine. The Software collects Data from Cisco Routers with Netflow and from Foundry/Brocade Switches with sflow.

Netflow in combination with the Cisco devices works fine.

The data from the Foundry/Brocade Switches doesn't fit together. Two Foundry SuperX with latest firmware are exporting sflow data for one 10Gbit/s Interface (this is the link beetween the two devices). If we compare the interfaces in Netflow Analyzer we will see 5,39GB Incoming Traffic on device 1 but only 37,35MB Outgoing Traffic on device 2. On the other side there are 21,54MB Outgoing on device 1 but 3,07GB Incoming on device 2 (see attachment). In my view, the data that will go out should come in on the over side.

What's the reason?

The switch configuration for sflow:

 slow-start 60 

interface ethernet 1/1
sflow forwarding

sflow version 5                                                  
sflow enable                                                     
sflow agent-ip 10.10.63.254                                      
sflow sample 128                                                 
sflow polling-interval 10                                        
sflow destination 10.10.10.10 9996    






Thanks for any comments!


(Please excuse my bad english)

                New to ADSelfService Plus?