The custom Monitor did not respond to the test request
Here is my custom monitor
SNMP OID .1.3.6.1.2.1.2.2.1.14
Monitor Name Interface Input Errors
Display Name Interface Input Errors
Polling Interval 15 (mins)
Units Errors (eg. Mbps)
i am getting other SNMP data from the same device. This is what i get when i test the monitor
Test results
The Monitor did not respond to the test request
Summary
Device Name 10.3.30.1
Monitor Name Interface Input Errors
Protocol SNMP
OID .1.3.6.1.2.1.2.2.1.14.0
Possible reasons
1. Check if SNMP is enabled on this device.
2. The SNMP request might have timed out
3. The OID may not have been implemented in the MIB.
4. The device might be down
if you notice for some reason its putting a .0 at the end of the oid but i dont have a .0 list in my oid for input errors. Please let me know how to correct this. Thanks
SNMP OID .1.3.6.1.2.1.2.2.1.14
Monitor Name Interface Input Errors
Display Name Interface Input Errors
Polling Interval 15 (mins)
Units Errors (eg. Mbps)
i am getting other SNMP data from the same device. This is what i get when i test the monitor
Test results
The Monitor did not respond to the test request
Summary
Device Name 10.3.30.1
Monitor Name Interface Input Errors
Protocol SNMP
OID .1.3.6.1.2.1.2.2.1.14.0
Possible reasons
1. Check if SNMP is enabled on this device.
2. The SNMP request might have timed out
3. The OID may not have been implemented in the MIB.
4. The device might be down
if you notice for some reason its putting a .0 at the end of the oid but i dont have a .0 list in my oid for input errors. Please let me know how to correct this. Thanks