SNMP Traps - HOW TO?
I have already asked this is a previous post but with the following TRAP that was sent how "EXACTLY" would i create a SNMP TRAP Processor to pick it up so that I can set it to a lower priority level.
.1.3.6.1.4.1.9.9.41.1.2.3.1.2.0: 20, .1.3.6.1.4.1.9.9.41.1.2.3.1.3.0: 4, .1.3.6.1.4.1.9.9.41.1.2.3.1.4.0: Syslog Trap, .1.3.6.1.4.1.9.9.41.1.2.3.1.5.0: 305005: No translation group found for icmp src
Furthermore only clogMessageGenerated is available when you use the "Load traps from Mib" for the CISCO-SYSLOG-MIB. this exact entry in the mib is not appearantly set up as a Trap within the mib however I am receiving it as a trap.
so im asking how exactly would i build a Processor for this exact instance? also can the Output of the message simply say "305005: No translation group found for icmp src" along with the remainder of the actually msg that got truncated?
.1.3.6.1.4.1.9.9.41.1.2.3.1.2.0: 20, .1.3.6.1.4.1.9.9.41.1.2.3.1.3.0: 4, .1.3.6.1.4.1.9.9.41.1.2.3.1.4.0: Syslog Trap, .1.3.6.1.4.1.9.9.41.1.2.3.1.5.0: 305005: No translation group found for icmp src
Furthermore only clogMessageGenerated is available when you use the "Load traps from Mib" for the CISCO-SYSLOG-MIB. this exact entry in the mib is not appearantly set up as a Trap within the mib however I am receiving it as a trap.
so im asking how exactly would i build a Processor for this exact instance? also can the Output of the message simply say "305005: No translation group found for icmp src" along with the remainder of the actually msg that got truncated?