SNMP on Cisco Catalyst
We used the demo version of Opmanager where all traps were working fine. On purchasing Opmanager we installed a new server to run the software and since then I can see the ports on the switches but no monitors work. When I test the monitor it responds with :
The Monitor did not respond to the test request
The SNMP host is configured correctly on the switches, at this point ALL traps have been enabled and the community strings are correct.
Any idea's as to how I can get this up and running?
The Monitor did not respond to the test request
The SNMP host is configured correctly on the switches, at this point ALL traps have been enabled and the community strings are correct.
Any idea's as to how I can get this up and running?