I curious to know something that I am not understanding. When I make a device template it asks me to query a device vai SNMP and IP Adress to see if the device exist and then it gives you an OID number. OpManager was indeed able to query the device via SNMP through the IP Address for this device but after I add the custom Monitor and run a test on the custom monitor, this is what I get:(See Below)
Can someone tell me what I am doing wrong? I am not sure what this means either -
3. The OID may not have been implemented in the MIB. I know that SNMP is enabled on the device because we were using SNMP on another NMS software that we were using right before this one. so #1 and 2 are out.. and I know the radio is on.. so #4 is out... so it has to be #3. Can someone explain? SO Frustrated at this point.
| |
 The Monitor did not respond to the test request |
| Device Name |
Knox Plant SM |
| Monitor Name |
Session Status Test |
| Protocol |
SNMP |
| OID |
| .1.3.6.1.4.1.161.19.3.2.2.1.0 |
|
1. Check if SNMP is enabled on this device.
2. The SNMP request might have timed out
3. The OID may not have been implemented in the MIB.
4. The device might be down
|
|
|
| |
|
