Guys,
Hope you can help, We have and MPLS network across 2Mb LL,
we have asked our provider to point all the Cisco routers to the Net flow
server and after some initial configuration changes we see all the devices.
We do however still have a few issues:
1. The QoS setting do not seem to be working, almost
everything is being reported under "000000", and Again QoS has been
configured on these routers by our Provider.
2. I had to manually change the interface speed to the
correct bits,(e.g. 2Mb = 2000000bits) but one of the routers says the max speed
is 12.7Mb and we have an exclamation mark saying to set the correct speed which
it is.
We are running Net Flow Analyser 8.6 Pro.
New to this, so your patience and help would be appreciated.