Dear Support,

I am using registered OpManager 8022 with NCM plugin.

I have just added the memory performance monitor for HPUX using cli.  However it is showing 0% memory utilization for all my HPUX servers.  CPU utilization monitor is working fine.  I am using HP-UX 11.23.

NCM is not able to detect changes made to my network devices.  OpManager syslog is working fine and I can see syslog messages captured and Change Detection have been enabled on all devices.  However when a backup is performed, all the changes will then be captured with similar timestamp.  It appears that NCM is not able to detect constant changes through syslog and will only poll and check for config differences whenever a backup is run.

I am adding Cisco 4400 series WLAN Controller to NCM.  It is able to detect the device but is not able to backup the config.  The error is as below.  It appears that the command use by NCM is wrong.

Entered into the enable login mode successfully.
copy running-config tftp://172.16.7.6/320_ConfigFile.txt
Incorrect usage. Use the '?' or key to list commands.
(Cisco Controller) > 

Thanks.