OID test for predictive failure of DELL RAID card
Hi,
I am trying to add a custom monitor for predictive failure of DELL RAID card.
The OID is 1.3.6.1.4.1.674.10893.1.1.200.570.0
This trap should send a message if a hard drive has a problem in the RAID configuration. It is a very important point to watch.
Specific MIB is added in the MIB folder of probe and central.
OID is added in the probe SNMP Trap processor
Custom monitor is added in the central.
When I add this monitor to the device and click the test key I have this answer :
-----------------------
The Monitor did not respond to the test request.
1. The probe might be down
2. Check if SNMP is enabled on this device.
3. The SNMP request might have timed out
4. The OID may not have been implemented in the MIB.
5. The device might be down
------------------------
Any idea ?
Thx
I am trying to add a custom monitor for predictive failure of DELL RAID card.
The OID is 1.3.6.1.4.1.674.10893.1.1.200.570.0
This trap should send a message if a hard drive has a problem in the RAID configuration. It is a very important point to watch.
Specific MIB is added in the MIB folder of probe and central.
OID is added in the probe SNMP Trap processor
Custom monitor is added in the central.
When I add this monitor to the device and click the test key I have this answer :
-----------------------
The Monitor did not respond to the test request.
1. The probe might be down
2. Check if SNMP is enabled on this device.
3. The SNMP request might have timed out
4. The OID may not have been implemented in the MIB.
5. The device might be down
------------------------
Any idea ?
Thx