NBAR enabled but not showing in Netflow Analyzer

NBAR enabled but not showing in Netflow Analyzer

Quick question-

I am evaluating this product, Netflow Analyzer, and would like to check out the NBAR function. Following the guide, I have enabled NBAR on my 2610XM router running "c2600-is-mz.122-16.bin".

At the console, I receive an output from "show IP NBAR Protocol-discovery", so I know it is working.

However, when I go to Netflow Analyzer I show "NBAR MIB Support: NO" under the device. I click on "set SNMP parameters" and choose update, no luck.

I then go to the NBAR configuration page and check status on all devices and interfaces. The same issue, I receive "NBAR Support: No" on the interface and device I know it is functioning on.

Any ideas?









                New to ADSelfService Plus?