Misconfigured devices, errors etc.
Hi all,
I was wondering if there is a way to get Opmanager to report on devices that does not have SNMP set up properly, for example the community string is wrong, or the device does not allow SNMP access from opmanager. Opmanager should not report the actual problem, just that there is one.
Also if WMI is not accessible due to logon failures etc.
If there are 100s of devices, you sometimes find yourself needing interface graphs, disk usage etc. but the device has some config problem that you did not know of.
Regards
Jacques
I was wondering if there is a way to get Opmanager to report on devices that does not have SNMP set up properly, for example the community string is wrong, or the device does not allow SNMP access from opmanager. Opmanager should not report the actual problem, just that there is one.
Also if WMI is not accessible due to logon failures etc.
If there are 100s of devices, you sometimes find yourself needing interface graphs, disk usage etc. but the device has some config problem that you did not know of.
Regards
Jacques