IPSLA
If you name an IPSLA monitor and delete it, you cannot reuse the name later. eg If you name an IPSLA "test", you cannot reuse "test" again, you need to use "test1", "test2" etc which gets a bit frustrating if you have done this over a few weeks especially as you have to close and reopen the window and retype all the settings again
Also, if you set up a "WAN Monitor" on a device that does not support it you still get a message that it has been done, it still shows up in OpManager but obviously never gets a reply
Also, if you set up a "WAN Monitor" on a device that does not support it you still get a message that it has been done, it still shows up in OpManager but obviously never gets a reply