Interface issue

Hi there:

Thanks for looking to this post...

I had been using OpManager V6 for quite a while and it has work sweet. I have upgrade to v7 and notice that under the switches and routers interfaces are huge amount of interfaces (on a router more than 400+) reported.

For example, I have a Cisco 3560-48 which has 48 copper ports + 4 gbits ports and I will expect to see 52 physical ports plus virtual ports like VLAN's, Null, etc.

Instead, I have 1595 interfaces, some in error but what I see are the same interface duplicated for every interface the is up. I mean, if I have 29 active ports I have 29 VLAN 1 interfaces reported, each with their own bandwidth usage, but it doesn't identify to which ports is associated to, it just says VLAN 1.

So instead of summarizing all VLAN bandwidth on a single interface, it's reporting the VLAN1 on every active port separately. And the same for all VLAN's running @ the switch.

What I did was delete all interfaces and run the rediscover option which returns all physical interfaces on the switch, fine up to this point. After 5 min I get back to check again the interfaces and I get 29 ports just for the VLAN 1. In total I get 1595 interfaces reported. Is not only one device with this issue, they are all router and switches device in my LAN.