Incorrect speed shown on Juniper SRX interface

Incorrect speed shown on Juniper SRX interface

Hello,

I've just downloaded the trial version of Netflow Analyzer. When viewing our Juniper SRX router the interface speed is shown in kbps which is incorrect.

Here is a graph from the router interface, note the Output Rate on the right side is facing the LAN clients. Note it is showing the speed at 4.9 Mbit/s:



In the Netflow Analyzer interface the throughput is listed as 525 kbps (ie: 0.525 Mbit/s)


The Windows client is showing similar speeds as the Juniper UI, incrementing in 500-600 KBytes/s:



I'm wondering if the netflow UI is incorrectly coded, showing kbits instead of KBytes, or if there is a configuration issue I'm missing.

Also the devices overview tab shows a completely different number: on the same fe-0/0/2.0 interface:


I appreciate any help here, I'm trying to track down a bandwidth hog at one of our branch offices and when I look at traffic by destination, the client I'm testing doesn't show anywhere near the bandwidth I know I've used (as per the windows network status ~4.8 GB).

Here's traffic stats destined for the client. Note I flushed the db and started from scratch, but this was the last 45 minutes of an adobe photoshop install over the network so it had to be much more than the 98MB showing. Previously when the windows bandwidth was showing 3GB this page was showing 12MB.


























                New to ADSelfService Plus?