Force10 config upload
I cannot get the Force10 switch to upload. When I configure the credentials all steps validate, but the config is not uploaded, message:
Credentials are valid. But the configuration file is not uploaded to the TFTP server. Login to the device manually and verify configuration backup using the above set of commands.
At the bottom it shows this command being used:
copy nvram:startup-config t ftp://172.16.50.65/2_ConfigFile.txt
If I manually try to enter the command on my force10 switch I get this:
% Error: Syntax error in the source path.
If I remove the "nvram" portion from the command:
copy startup-config t ftp://172.16.50.65/2_ConfigFile.txt
!...!
29976 bytes successfully copied
It works. How can I force Opmanager NCM to change the command?
Credentials are valid. But the configuration file is not uploaded to the TFTP server. Login to the device manually and verify configuration backup using the above set of commands.
At the bottom it shows this command being used:
copy nvram:startup-config t ftp://172.16.50.65/2_ConfigFile.txt
If I manually try to enter the command on my force10 switch I get this:
% Error: Syntax error in the source path.
If I remove the "nvram" portion from the command:
copy startup-config t ftp://172.16.50.65/2_ConfigFile.txt
!...!
29976 bytes successfully copied
It works. How can I force Opmanager NCM to change the command?
New to M365 Manager Plus?
New to M365 Manager Plus?
New to RecoveryManager Plus?
New to RecoveryManager Plus?
New to Exchange Reporter Plus?
New to Exchange Reporter Plus?
New to SharePoint Manager Plus?
New to SharePoint Manager Plus?
New to ADManager Plus?