Error Removing Interfaces
Hi,
Any time i go to remove an interface from a Switch/router via the interface tab of the device , Opmanager reports tht it is unable to remove interfaces.
This very anoying as some of or Switches would have over 300 ports ad we would only want to view 5-6 of them.
Also, when i go to alter a setting under the Interface Templates, e.g : Discards on port, after i have made the change, saved it and saved it again to the list of Ethernet (6) interfaces, all of the ports that i was previously NOT monitoring, now appear, this generates massive amouts of alarms, and i then have to go through eash switch and router and un-montior the ports i dont want. This is VERY anoying.
I am on the latest build 7021.
Any time i go to remove an interface from a Switch/router via the interface tab of the device , Opmanager reports tht it is unable to remove interfaces.
This very anoying as some of or Switches would have over 300 ports ad we would only want to view 5-6 of them.
Also, when i go to alter a setting under the Interface Templates, e.g : Discards on port, after i have made the change, saved it and saved it again to the list of Ethernet (6) interfaces, all of the ports that i was previously NOT monitoring, now appear, this generates massive amouts of alarms, and i then have to go through eash switch and router and un-montior the ports i dont want. This is VERY anoying.
I am on the latest build 7021.