Custom Monitor not working - Please help
I am having a real problem in getting custom monitor to work. It is appending ".0" to the OID I specify causing a failure..
Below is the OID for "Memory Utilization" on Cisco devices present in the "Resource Monitors" section and it works just fine..
(.1.3.6.1.4.1.9.9.48.1.1.1.5.1*100)/(.1.3.6.1.4.1.9.9.48.1.1.1.5.1+.1.3.6.1.4.1.9.9.48.1.1.1.6.1)
However, when I setup a custom monitor using on of the above OIDs it fails, very likely becuase of a ".0" appended at the end. e.g a specified OID of ".1.3.6.1.4.1.9.9.48.1.1.1.5.1" is being modified as ".1.3.6.1.4.1.9.9.48.1.1.1.5.1.0".
When I test the custom monitor I get the error message "The Monitor did not respond to the test request"
There is something obvious that I am missing becuase numbers attempts over the past several days have not worked. Please help.
Thank you.
Below is the OID for "Memory Utilization" on Cisco devices present in the "Resource Monitors" section and it works just fine..
(.1.3.6.1.4.1.9.9.48.1.1.1.5.1*100)/(.1.3.6.1.4.1.9.9.48.1.1.1.5.1+.1.3.6.1.4.1.9.9.48.1.1.1.6.1)
However, when I setup a custom monitor using on of the above OIDs it fails, very likely becuase of a ".0" appended at the end. e.g a specified OID of ".1.3.6.1.4.1.9.9.48.1.1.1.5.1" is being modified as ".1.3.6.1.4.1.9.9.48.1.1.1.5.1.0".
When I test the custom monitor I get the error message "The Monitor did not respond to the test request"
There is something obvious that I am missing becuase numbers attempts over the past several days have not worked. Please help.
Thank you.