Configuration Snapshot and Sync Configurations

I noticed when you configure the DeviceExpert application to enable "Real-time Change Detection", it doesn't actually write the changes that are made to actually enable this feature to the start-up config. This was noticed in the HOME screen, " Configuration Conflict Snapshot" table.

I selected three switches I am demoing with the product and chose, "Copy running to start-up". The DeviceExpect failed to do this. Log below.

----------
copy startup-config tftp
Login OK
**
sw06#copy startup-config tftp
Address or name of remote host []? 10.30.102.7
Destination filename [sw06-confg]? 2_ConfigFile.txt
!!!!
11706 bytes copied in 0.128 secs (91453 bytes/sec)
sw06#

Entered into the enable login mode successfully.
copy running-config tftp
Address or name of remote host []? 10.30.102.7
Destination filename [sw06-confg]? 2_ConfigFile.txt

Entered into the enable login mode successfully.
copy running-config startup-config
!!!!
11759 bytes copied in 2.172 secs (5414 bytes/sec)
sw06#copy running-config startup-config
Destination filename [startup-config]?

Entered into the enable login mode successfully.
copy startup-config tftp
%Error copying nvram:copy (Invalid argument)
sw06#