Cisco Catalyst 2924XLV- Interface traffic not shown
After adding my the IP address of my switch to Opmanager, the device and some details showed up. I can get reporting on CPU util, memory util, but nothing else. I would like to have the ability to report on Rx and Tx util as well as Rx and Tx Traffic.
I tried to test by clicking the 'Test Monitor' button and got the following message: "The Monitor did not respond to the test request"
Here's my config from the switch:
snmp-server community <password> RO
snmp-server enable traps snmp authentication linkdown linkup coldstart
What am I doing wrong?
I tried to test by clicking the 'Test Monitor' button and got the following message: "The Monitor did not respond to the test request"
Here's my config from the switch:
snmp-server community <password> RO
snmp-server enable traps snmp authentication linkdown linkup coldstart
What am I doing wrong?