Cisco bandwidth monitoring
Hello,
I have a Cisco Catalyst 2900, which I want to monitor.
I have configured the following:
- Imported the switch into OpManager
- Defined the switch type Catalyst 2900 (on the right side: Configure Device Type)-- Set the SNMP to the correct values
I clicked Discover to discover all the interfaces. This worked perfectly.
But: when I add a Traffic Monitor, it does not measure the value. When clicking on the Test-button (in the edit-screen of a monitoring task), it does NOT give an error. But It gives me a correct value, neither.
I did not fill in username/password/prompt for Telnet.
Can someone tell me what I'm doing wrong / forgetting to set?
I have a Cisco Catalyst 2900, which I want to monitor.
I have configured the following:
- Imported the switch into OpManager
- Defined the switch type Catalyst 2900 (on the right side: Configure Device Type)-- Set the SNMP to the correct values
I clicked Discover to discover all the interfaces. This worked perfectly.
But: when I add a Traffic Monitor, it does not measure the value. When clicking on the Test-button (in the edit-screen of a monitoring task), it does NOT give an error. But It gives me a correct value, neither.
I did not fill in username/password/prompt for Telnet.
Can someone tell me what I'm doing wrong / forgetting to set?