Adding SNMP Monitor failure

Adding SNMP Monitor failure

Hi,

I noticed that adding an SNMP monitor to any device template fails with a time out, further digging I discovered that the community being used by opmanager is public to fetch the OID result in question. Why is the user not allowed to select the correct credentials i.e. community in order to query the device, suppose I am not using SNMPv1/2, in this case what am I supposed to do? public community is not recommended anyway.. Sounds like each time a user needs to add a monitor they will need to configure public community on the switch in order to continue, then remove it.. Is there a way to modify this behavior?

regards,
Omar

                New to ADSelfService Plus?