(Un)Ability to copy/adjust/use custom monitor
Hi all,
I've run into a very annoying and inconvenient problem.
A short while ago OpManager Support helped me out with some custom monitors.
These are to monitor AKCP Environmental SensorProbes (and if I succeed to copy-adjust-use in another way for Powerware UPS's). My problem first is about the AKCP-probes.
With OpManager-support help we created custom monitors, added them to devices and started gathering data from these probes. So far, so good. Then I tweaked the custom monitoring with thresholds. So far, so good.. But.. since I want to monitor these probes with a certain bandwidth for good values (RH 40-60 %, Temp 20-25 C) I copied these custom monitors, adjusted their names, tweaked their thresholds the other way around and started adding them to devices.
Well.. it all seems to go fine until the adding of the monitors..
E.g.: I've probes called Temp_Low and Temp_High, Temp_Low fails whenever T falls below 20C, Temp_High fails whenever it exceeds 25C. For both custom monitors I use the same OID, but I've an entirely different threshold configuration for them. When I add Temp_Low to device A it goes fine, when I add Temp_High to device A afterwards, Temp_High fails to be added and OpManager says 'Unable to configure Graph'. When I clear all Custom Monitors, add Temp_High to device A it goes fine, when I add Temp_Low to device A afterwards it fails to be added again. Both custom monitors work fine when added solely to a device.
Anybody willing and able to help me with this?
Regards,
Minollie
PS: I'm open to suggestions as well as providing you with more information.
I've run into a very annoying and inconvenient problem.
A short while ago OpManager Support helped me out with some custom monitors.
These are to monitor AKCP Environmental SensorProbes (and if I succeed to copy-adjust-use in another way for Powerware UPS's). My problem first is about the AKCP-probes.
With OpManager-support help we created custom monitors, added them to devices and started gathering data from these probes. So far, so good. Then I tweaked the custom monitoring with thresholds. So far, so good.. But.. since I want to monitor these probes with a certain bandwidth for good values (RH 40-60 %, Temp 20-25 C) I copied these custom monitors, adjusted their names, tweaked their thresholds the other way around and started adding them to devices.
Well.. it all seems to go fine until the adding of the monitors..
E.g.: I've probes called Temp_Low and Temp_High, Temp_Low fails whenever T falls below 20C, Temp_High fails whenever it exceeds 25C. For both custom monitors I use the same OID, but I've an entirely different threshold configuration for them. When I add Temp_Low to device A it goes fine, when I add Temp_High to device A afterwards, Temp_High fails to be added and OpManager says 'Unable to configure Graph'. When I clear all Custom Monitors, add Temp_High to device A it goes fine, when I add Temp_Low to device A afterwards it fails to be added again. Both custom monitors work fine when added solely to a device.
Anybody willing and able to help me with this?
Regards,
Minollie
PS: I'm open to suggestions as well as providing you with more information.